Specifications

Packer Face Plate	1500mm x 750mm = 1.13 square metres
Effective Displacement	2.71 cubic metres/stroke
Volume per hour	90 cubic metres
Cycle Time	106 seconds
Ram Force	Adjustable to a maximum pressure of 31250kg
Cylinder Stroke	3.1 metres
Cylinder Bore Diameter	5" - 127mm
Cylinder Shaft Diameter	3" - 76mm
Chamber Length	2400mm
Ram Penetration	600mm

Hydraulic Power Pack Specifications

• 15kw Electric Motor 1440 rpm IP55 rated
• 180 litre reservoir BPHLPZ-46
• Vickers CTop7 Valve 24 volt
• Vickers Vane Pump
• Hydraulic Pressure 240 Bar (3500 psi) maximum

Electrical Specifications

• Telemecanique Proximity Switches
• Push Buttons
• Enclosures
• Star Delta Starter
• Power Factor Correction
• Hour meter

Electrical Requirements

• 415 volt 3 phase with earth and one neutral

Features of the Scarlett Static Compactor 90

The ideal choice for smaller capacity Transfer Stations and commercial locations in New Zealand. The Scarlett Static Compactor 90 incorporates the latest in design and technology. Some of these features are listed below.

Frame Design

Incorporation of the entire Hydraulic system including tank and motor within the frame of the Compactor, not only does this save space but it also makes for easier installation requiring only underground conduit for electrical and control services not hydraulic lines. Easy access for servicing of hydraulics is provided through underneath and removable top panel on main Compactor Body. The local control panel is accessible through a lockable flap at the rear of the compactor.

Durable Materials

• Compactor Main Frame Folded 10mm plate
• Covers and panels 5mm plate
• Compactor piston Folded 10mm plate with reinforcing bars underneath
• Bottom of Compactor chamber (floor) Folded 10mm plate with reinforcing bars underneath

Wear Guides

The Compactor Piston has UHMWPE plastic wear strips on either side and on the bottom. When replacement is required they are easily unbolted and replaced.

Vickers Hydraulics

The hydraulic system is using all Vickers Components with a Vane Pump and a CTop7 valve. All hosing and fittings are Aeroquip. Both these products are of extremely high standards and are serviceable world wide. The benefits of using Vickers Hydraulics are long term performance smooth quiet running. Vickers Hydraulics provide proven performance and reliability.

Installation

On sight fitting to place the Compactor into the correct position and drill the concrete. 12 x 20mm liebig-anchor bolts.

Canopy on Hopper

Constructed from steel box section frameing and folded and rolled zinc plated steel.